6 of 12
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
WS2641
OPERATION
STRAIGHT CUTS
1.
Pull up on lock lever and slide fence to the desired
width.
2.
Push lock lever down to latch the fence in position.
3.
Slide LVP or WPC plank against the fence (2), then
push it forward under the blade.
4.
Gently hold material against the blade and turn the
drive crank (4).
5.
Continue turning the drive crank until material has
been scored completely.
6.
Bend the material to snap it along the score line.
3
2
CURVED CUTS
1.
Set the blade depth.
2.
Pull up on the fence lock lever and remove the
fence.
3.
Draw a line on your material representing the path
you plan to cut.
4.
Align your line with the arrow indicator (6) on the
Cruiser and push firmly under blade.
5.
Turn the drive crank and allow the material to be
pulled under the blade.
6.
Rotate the material as necessary while turning the
drive crank to ensure that the score wheel follows your
line.
7.
Continue turning drive crank until material has been
scored completely.
8.
Bend the material to snap it along the score line.
Turn drive crank
continuously
Rotate
material
to cut
curves
6
2
3
CAUTION
Rotating material when the drive is not turning, or attempting to follow a diameter smaller
than 6" (152mm) or radius corner smaller than 3" (75mm) will crack the blades!
!
!
