MT84G User’s Manual V0.1
___________________________________________________________________________________
42
Note: In the case of entering odd number of hex value during configuration, the
last byte of data becomes invalid.
6.8 Output Protocol
The output protocol applies to UART/USB VCP interface, which, when enabeld,
transforms data into below format:
[0x03] + [Length] + [Data]
Output Data Only*
Output Protocol
6.9 GS Replacement
GS (0x1D) stands for Group Separator and is used as delimiters to mark fields
of data structures. As a control code, GS is non-displayable in many text
applications and therefore it is requested to be replaced with displayable
character in some use cases. In short, this function replaces 0x1D with a
displayable ASCII character. GS can be replaced by 0x20 ~ 0x7E in ASCII
table.
Example: to set GS Replacement as ‘C’
1. Scan
Enable GS Replacement
2. Scan
Set GS Replacement
3. Convert “C” into Hex equivalent as 43
4. Scan
4
,
3
respectively from
8.1 Data 0~F
5. Scan
Save Configuration
from
8.2 Save & Abort
Enable GS Replacement
Disable GS Replacement*
