Marta MT-4265, User Manual

8 



Do not switch on an empty device without food for more than 15 minutes. 



Maximum allowable continuous operating time is 4 hours. 



Do not allow products to come into contact with heating elements. 



Keep water away from hot glass as it may crack. 



Do not physically expose the door or glass - do not place any objects or lean on it. 



Always unplug the appliance and let it cool down before cleaning and removing parts. Keep unplugged when not in use. 



WARNING: This device heats up during use. The temperature of the door or other surfaces may be exceeded when the appliance is in operation.  
Do not touch the hot surfaces or heating elements inside to avoid burns. Use special accessories, kitchen tackles or mittens. 
WARNING: Failure to observe safety precautions may result in fire, electric shock, or burns. Damage to the appliance caused by improper use will exempt the seller from warranty 
service. 

BEFORE THE FIRST USE 



Unpack the appliance and remove all packaging materials and labels. Store warning labels (if available) and the product serial number plate on the housing! 



Clean the device with a damp cloth, clean the accessories in soapy water rinse thoroughly and dry. 



Make sure that there are no packaging materials or foreign objects (including products) inside.  



Switch on all heating elements by selecting heating mode 

, set the maximum temperature to 230°C and timer for 15 minutes. Some smoke or odour may be produced at the first switch-on, 

this is normal and not a malfunction. At the end of this cleaning procedure, let the unit cool down, after which it will be ready for operation. 

USING THE APPLIANCE 

SWITCHING ON 



Make sure the device is switched off (timer adjustment knob is in the «OFF/0» position). Connect the device to the power supply. 



Install a bake tray and/or wire rack, place the food. If the food is cooked on the wire rack/skewer/rotisserie, place the bake tray on the bottom level to prevent oil/grease/juice droplets from getting 
onto the heated surfaces. 



Turn the temperature adjustment knob "3" to set the desired temperature from 100 to 250°C. 



Then turn the heating mode selection knob "5" to set desired heating mode. 



The rotation of the skewer/rotisserie is activated automatically when the operation mode of the upper heating elements or the upper + lower ones, is selected. 



To turn on the device, set the timer from 1 to 60 minutes by turning the timer setting knob "6". 



The inner light and indicator light "4" will illuminate, the device starts working. 



After the set time has elapsed, an audible signal will sound, the inner light & indicator light will go out, and the device will stop working. 
If the products are not ready yet, set the additional operating time by turning the timer knob.  
In order to get better cooking performance, it is recommended to pre-heat the oven about 10-15 minutes. DO NOT USE THE APPLIANCE MORE THAN 4 HOURS WITHOUT A BREAK. 

HEATING MODE SELECTION 

To set the desired heating mode, turn the heating mode adjustment knob "5" to one of the following positions: 

 - the upper heating elements & rotation of the skewer/rotisserie.                

  - the lower heating elements operating mode.  

 - the upper & lower heating elements & rotation of the skewer/rotisserie.     

 - all heating elements & operating modes are off.