14
15
DPL50PR002 - ENGLISH
DPL50PR002 - ENGLISH
6.0 DIRECTIONS FOR USE
Plug the unit into a 230V
AC
single-phase power socket
Press the ON switch and check that the power ON light comes on (if it does not,
check that the unit starts heating anyway once you have turned the thermostat: in this
case, have the faulty light bulb replaced).
Set the knob to the desired power level.
Wait a few minutes until the operating temperature is reached, signaled by the rele-
vant indicator light going off.
Proceed with hot working
At the end of use, allow the top to cool before putting it away
If you want to move the equipment (for example to clean), wear thermal gloves EN
407.
7.0 TROUBLESHOOTING
FAULT
POSSIBLE CAUSE
REMEDY
A
The light does not come on when
the switch is turned on during the
heating phase.
No power to 230V
AC
(110
AC
/240
AC
)
power socket
Electrical system protection has
tripped (thermal-magnetic circuit
breaker, circuit breaker, residual
current device).
1. Unplug the power cable.
2. Check that the fault is not
attributable to the device.
3. If it is a fault with the electrical
system, call in a professional
electrician to make the necessary
repairs.
4. Plug the appliance back in and
turn it back on.
5. If it is the device that has
caused the electrical system
protection to trip, contact the
dealer or manufacturer to arrange
for replacement or repair as
necessary.
Faulty bulb.
Contact the dealer or
manufacturer to arrange for
replacement or repair as
necessary.
B
The device and top surface of
the appliance remain cold to the
touch.
No mains power
Proceed as indicated in point A
Check the thermostat
temperature setting.
Break in heating element.
Contact the dealer or
manufacturer to arrange for
replacement or repair as
necessary.
Break in power cable.
C
The device fails to reach the re-
quired temperature.
Intermittent contact in socket /
pug connection.
Check that the plug is inserted
correctly into the mains socket.
Intermittent contact inside the
appliance.
Unplug the device from the
power socket immediately.
Contact the dealer or
manufacturer to arrange for
replacement as necessary.
