AS Martem
Data Concentrator TELEM-AGC User Manual
Rev. 1 / 2018
AS MARTEM
Tel: +372 639 7979
martem@martem.eu
www.martem.eu
-
10
-
7. DIP switches
Reset:
Switch RESET to ON state and then back to OFF state for Reset operation
Dft. Set:
To apply default setup:
1. Switch DFT. SET to ON state
*Alert indication LED starts blinking within 5 seconds
*Alert indication LED will blink for 2 seconds
2. Switch DFT. SET back to OFF state when the alert indication LED
is
blinking
to apply default setup
*If DFT. SET is switched back to OFF state when the alert indication LED is not
blinking, default setup will NOT be applied
8. Indication LED-s
MODEM
– green LED – indicates the 4G (3G) modem network connection
RUN
– green LED – blinking green indicates that the program is running
ALERT
– red LED – failure
Green LED-s for serial communication ports for RX, TX indication.
9. Configuration tool
The Telem-AGC device is configured with Telem-GWS software.
The configuration process is described in Telem-GWS software manua
