AS Martem Data Concentrator TELEM-GW6e User Manual
Rev. 11 / 2013
Akadeemia tee 21/6 Tel: +372 639 7979 E-mail: martem@martem.eu
12618 Tallinn Fax: +372 639 7980 www.martem.eu
Estonia
- 54 -
12. Firmware Update
12.1 Loading firmware through Secure Digital (SD) Memory Card slot
Updating firmware:
1. Connect Secure Digital (SD) Memory Card to your computer
2. Extract the compressed firmware update file (provided by Martem AS)
to your SD Memory Card
3. Disconnect the card from your computer
4. Insert the card to TELEM-GW6e SD Memory Card slot
* SD Memory Card slot is located at the back of the device
5. Perform reset operation to TELEM-GW6e device
6. Wait until the device resumes to it’s normal operation state
7. Firmware update is complete. Remove the SD Memory Card and check
if firmware update was successful
Checking results of the firmware update operation:
1. Connect the SD Memory Card to your computer
2. Open the folder you extracted earlier
3. Check if the file “res.txt” is present and open it
4. Check the state of installed files at the last part of the file
*If the state of update files is OK - firmware update was successful
12. Notes
•
If not stated otherwise on the individual pages of this document, AS
Martem reserves the right to make modifications.
•
Although the contents of this publication have been checked for
conformity with the hardware and software described, we cannot
guarantee complete conformity since errors cannot be excluded.
•
The information provided in this manual is checked at regular intervals
and any corrections that might become necessary are included in the
next releases.
•
Any suggestions for improvement are welcome.
•
The contents of this manual are subject to change without prior notice.
