AS Martem
Data Concentrator TELEM-GWM User Manual
Rev. 2 / 2015
AS MARTEM
Tel: +372 639 7979
martem@martem.eu
www.martem.eu
-
8
-
5. Firmware update
NB! Before updating to new firmware read the setup from your device, and
make a backup.
•
Copy the compressed (*.7z) firmware update file (provided by Martem AS) to
your computer
•
Set up SSH connection with GW6 (see chapter 11.2) if you have not done this
before in this session or changed users. Login as martem. If you have not
changed the password then default password is provided by Martem AS
•
Press the “
Upd.
” button next to SSH settings
•
Press the pick button and select the copied update file (file will be
automatically unpacked to temporary folder)
•
Press the “Update” button, the update process starts
•
Wait until the device resumes to its normal operation state (“Run” LED will
start slow blinking again)
•
Firmware update is complete. Check if firmware update was successful.
Checking results of the firmware update operation:
•
Press “Get Result” button
•
Check the state of installed files at the last part of the file. If the state of update
files is OK - firmware update was successful.
