AS Martem
Data Concentrator TELEM-GWM User Manual
Rev. 2 / 2015
AS MARTEM
Tel: +372 639 7979
martem@martem.eu
www.martem.eu
-
9
-
6. Default setup, indication
Reset:
Switch RESET to ON state and then back to OFF state for Reset operation
Dft. Set:
To apply default setup:
1. Switch DFT. SET to ON state
*Alert indication LED starts blinking within 5 seconds
*Alert indication LED will blink for 2 seconds
2. Switch DFT. SET back to OFF state when the alert indication LED
is
blinking
to apply default setup
*If DFT. SET is switched back to OFF state when the alert indication LED is not
blinking, default setup will NOT be applied
For operation
MODEM – green LED – fast blinking (couple times per second) indicates that modem
is not connected, slow blinking (once per second) indicates that modem is
connected, no blinking indicates that modem is not connected/fault.
RUN – green LED – blinking green indicates that the program is running
ALERT – red LED – failure
For communication (RS232 ports)
Green LED's – RX, TX