7
Fitting the Safety Guard
m
WARNING!
The safety guard must be properly installed.
The safety guard provides partial protection from the risk of
thrown objects to the operator and other bystanders.
1. Place the safety guard over the blade shaft and snap into
place (Fig. 3).
2. Now the diameter of the protection area is 9 in. (23 cm).
3. If needed, you can flip up the steel edger guide + flower
guard onto the motor cover. This will allow you maximum
use of the SharperBlade
™
.
m
CAUTION!
Be careful when operating the machine
while steel flower guard is removed or raised.
Adjusting the Telescopic Shaft
1. Loosen the telescopic shaft adjustment knob (Fig. 4).
2. Pull and adjust the shaft to a comfortable height (Fig. 4).
3. Tighten the knob once the desired length is achieved
(Fig. 4).
Application
Inst Changing Blade
1. Disconnect the main plug.
2. Remove screw knob and the washer (Fig. 5).
3. Assemble the SharperBlade
™
to the electric grass trimmer
+ edger (Fig. 6).
4. Place the washer on the SharperBlade
™
and tighten with
the screw knob (Fig. 7).
Safety guard
Fig. 3
Telescopic shaft
adjustment knob
Twist the knob
clockwise to
tighten
Twist the
knob counter-
clockwise to
loosen
Fig. 4
Screw knob
Washer
Fig. 5
SharperBlade
™
Fig. 6
Washer
Screw knob
SharperBlade
™
Fig. 7
