Spring out each of the rear splay arms from its transit position and swing it
up into the receptor at the rear of the frame. Secure it in the 0
°
position by
inserting the quick release pin stored at the rear of the enclosure into the
hole in the arm.
Using front and rear motors
Step 1a
Position the frame upright with its front on the floor. Attach the chain motors
to the suspension frame.
Step 2a
Roll the first box up to the frame. Remove the pins at the front of the frame
which secure its captive front tongues and locate the front tongues within
the front rigging assembly of the box . Secure the tongues in position with
the quick release pin.
Note that a pin is locked when its central button is out.
Spring out each of the rear splay arms from its transit position and swing it
up into the receptor at the rear of the frame. Secure it in the 0
°
position by
inserting the quick release pin stored at the rear of the enclosure into the
hole in the arm.
Step 3
Gradually lift the frame using the motor(s) so that the lower rear corner of
the lifted box is approximately 1m above the floor. Remove its wheelboard
Martin Audio – W8L Flying System
E
NGLISH
9
GUIDES
>
<
CONTENTS
APPLICATIONS GUIDE
ENGLISH ONLY