Basic service
15
3 If replacing a lamp, grasp the old lamp
by the reflector and pull it out of the
holder. Then pull the socket off the
lamp. Do not pull the wires.
4 Push the socket fully onto the pins of
the new lamp.
5 Clean the glass bulb with the cloth
supplied with the lamp, particularly if
your fingers touched the glass. A
c le a n , l in t - fr e e c l o th w e tte d w i t h
alcohol may also be used.
6 Gently push the lamp into the holder
until it snaps into place.
7 Replace the fixture cover and tighten the access screws, taking care not to trap any
loose wires.
F U S E S
The Ego uses a time-delay fuse for protection against current overload. An
indication that the fuse may have blown is that when power is applied the lamp
does not light and the fan does not operate.
If the fuse blows repeatedly, there is a fault with the unit that requires service by a
Martin technician.
Never bypass the fuse or replace it with one of another size or rating.
Repla cing t he mai n f use
1 Unplug the mains cable from the input
socket.
2 Remove the six access screws from the
cover and lift it off
3 The fuse can be found on the circuit
board, a diagram of which can be found
on the inside of the fixture cover. Use this
to locate the fuse.
4 Remove the fuse and replace the fuse
with one of the same type. The fuse
