STEP 7: INSTALL OPTIONAL DEFLECTOR (SCRAPER)
NOTE:
The Deflector (Scraper) is recommended when operating in wetter conditions, or damp
stringy residue, to reduce wrapping.
NOTE:
The Deflector (Scraper) comes in pairs of left and right for left and right wheels.
Intersected Configuration ( Wheel in front hole)
1)
Place the deflector (Scraper) on the back of the assembled wheel unit (previously assembled in
step 6) as shown here and pass the flange bolt (BFS0156) through the wheel assembly and the
deflector and attach the flange nut (NFSL007) hand tighten and locate the deflector as shown
and torque the flange bolt (BFS0156) to 116 ft
-
lbs being careful not to allow the deflector to ro-
tate during bolt tightening.
2)
The wheel marked TW3813
-
L4 (Or RTW1412.5
-
L4 for the Razor wheel) is for use on the left side
of the frame (as viewed from behind the machine). Repeat for opposite side.
NOTE: When the deflector (scraper) is to be installed the washer (WSN0064) is NOT used
10
DEFLECTOR
(SCRAPER)
(ITD STW L)
(SHOWN IN CORRECT
POSITION)
FLANGE BOLT
(BFS0156)
FLANGE NUT
(NFSL007)
