When the Signer is in the Count UP mode, the system runs until all forms are signed and burst. When
the Signer is in the Count DOWN mode, both machines stop when the count on the signer is down to
zero. *The burster always counts up. To continue, separate the unsigned forms from the signed forms
and clear them out of the Signer. Use the JOG keys on the signer to expose the joining perforation.
On the Burster, press RUN to finish bursting the batch of signed forms.
X
If RUN on the Burster is pressed while the Signer is displaying any message other than
“HOLD”, the Burster will run by itself. If there is a loop of forms between the Signer and
Burster, the forms may be torn when the loop is taken up. When the Burster can no longer feed
forms, it will stop and display an error code.
7.2.3 Models 911/968 System, Stand Alone Operation
To operate either the Signer or the Burster independently, turn off the other machine or disconnect the
911/968 cable at either end.
8.0 TROUBLESHOOTING GUIDE
If a procedural error is made during setup of programming, the Model 911 displays a specific
message describing the error, such as “Invalid Executive Code”. To correct a procedural error, press
CE and try again. If the message is repeated, consult the OPERATION section to verify the procedure.
If the error message is repeated again, turn the Model 911 off and on again, and repeat the setup or pro-
gramming steps. If the Model 911 does not perform as described in the OPERATION section, call
your dealer, or the Martin Yale Technical Assistance line at 260-563-0641.
In case of an error in the running sequence or timing of the mechanism, the display will show
“System Error, Error Number _ _”. Please note this error category number. Then press STOP to get
the “Error Reference Number”, which indicates a specific error in that category. Please refer to Section
10.0 ERROR CODE EXPLANATIONS for remedies. If a system error persists, call your dealer, or the
Martin Yale Technical Assistance line at 260-563-0641.
Following is a list of possible problems and corrective actions.
1.
No Message in the display -
Make sure the power cord is plugged into a live AC outlet.
Check the power fuse in the rear panel for an open filament of a burnt spot. Replace a
defective fuse only with the same type and rating fuse.
2.
Control Panel will not accept an input -
Consult the OPERATION section to verify input
sequence.
3.
First prompt after power on is not “Enter Executive Code” -
Check to see that the lock key
is out of the rear panel switch. Turn power off and on again.
4.
Security code is not recognized -
Press CE and reenter your security code. If the security
code still is not recognized, reprogram it by the procedure in the PROGRAMMING section of
this manual.
5.
Display indicates “Cover May Be Opened”, but cover is stuck -
Rock the cover up and
down at both sides while the message is displayed. If necessary, press UNDO and reenter the
security code.
6.
Signature plate holder won’t slide -
Check to make sure that the set screw is loose. Gently
tap the right end of the signature plate holder.
10
