12
Threading Laminating Film…
These instructions apply to poly-in film rolls (shiny side out, dull side in)
1. For the top supply roll place the mandrel ends into the slots in the top of the laminator. If you are
facing the front of the laminator the film should unwind toward you from the bottom of the roll as in
Figure 3 on the next page.
Figure 3
2. Pull 6"-12" of film from the top roll. Pass the film under the idler bar and over the roller. Make sure
the shiny side of the film is against the roller.
3. For the bottom supply roll, remove the feed table. Place the mandrel ends into position in the lower
mandrel holder slots. Return the feed table to its proper position before operating the laminator. If you
are at the front of the laminator the film should unwind away from you at the bottom of the roll as in
Figure 4 below.
Figure 4
