7.0 – 10-Up Format Gutter Cut
Figure 4
Figure 4 shows the 10-Up Format Gutter Cut that is to be used in the GC10. There is a Card Template CD included with
your Model GC10 BCS to help lay out your personal business cards.
For the highest quality cards, the print MUST be parallel with the sheet and consistently repeatable, meaning that the print
must be in the same exact location every time.
251 Wedcor Avenue ¦ Wabash, Indiana 46992
Phone (260) 563-0641 ¦ Fax (260) 563-4575
Toll Free Phone (800) 225-5644 ¦ Email: info@martinyale.com
Website: www.martinyale.com
M-S027928
Rev.4 1/29/13
Model GC10 Single Pass Business Card Slitter
Installation, Operation & Maintenance Instructions
Specifications
Feeding Method
Continuous Top Feed
Speed
2,400 Cards/Hour
Sheet Capacity
50 sheets
Sheet Size
8 ½” x 11”
Paper Weight (cover stock)
65# to 100# (150 – 275 gsm)
(*will not do translucent stock)
6.0 pt. to 12 pt.
Digital Counter
job & life count, resettable
Electrical (USA)
115VAC 60 Hz, 1 Amp
Dimensions (LxWxH)
21” x 22” x 14”
(with scrap drawer open)
36” x 22” x 14”
Shipping Weight
97 lb.
Serial No. _________________
Table of Contents
Introduction
Page 1
Safety Notes
Page 1
Initiation
Page 1
1.0 – Nomenclature
Page 2
2.0 – Machine Setup
Page 4
3.0 – Machine Settings
Page 4
3.1 – Paper Guide Setting
Page 4
3.2 – Retarder Adjustment
Page 4
4.0 – General Operation
Page 5
4.1 – Overall Operation
Page 5
4.2 – Dejamming
Page 5
4.3 – Stopping the GC10
Page 5
4.4 – Safety Interlock
Page 5
4.5 – Counter Function
Page 5
5.0 – Maintenance
Page 6
5.1 – Feed Wheel
Page 6
5.2 – Black Rubber Wheels
Page 6
5.3 – Other Maintenance Topics
Page 6
6.0 – Troubleshooting
Page 7
7.0 – 10-Up Format Gutter Cut
Page 8
Introduction
Thank you for selecting the GC10 Single Pass Business Card Slitter. Your business card slitter, or BCS, and all the
components were 100% tested at our factory. We tested all critical operations, verifying that your machine is fully
functional and ready to operate.
Please read and understand this manual completely before attempting to operate this BCS. This will prevent common
problems and eliminate operator-associated errors. Understanding these instructions will provide years of excellent
performance from a quality machine.
Scope of Application:
The GC10 Single Pass Business Card Slitter is a machine for cutting
in the 10-up gutter cut format
.
This unit should be fed with card stock!
Cutting other types of materials can cause injuries or may
damage the BCS (e.g. destruction of the unit)
Installation:
- Unpack and set the machine upright with the controls facing you.
- See Section 2.0 Machine Setup
The socket outlet shall be installed near the equipment and
shall be easily accessible!
Only operate this machine in an enclosed office environment.
Keep enough distance to the surroundings when installing the
machine.
