***STEP 11 CONTINUED***
FORCE SETTING
Force settings
are automatically set to the proper minimum level by the Martin “Smart
computer”, each time the door is opened and closed. If the force needs to be changed,
press and hold the “P” button for about 20 seconds.
UP FORCE
LED #1 and #3
should be blinking.
Press and release the "+" or "-" button once. The
illuminated LEDs around the display will display the current force setting. By pressing the
"+" or "-" key, the force can be increased (+) or decreased (-). The force should be set as
low as possible. Once the desired force is selected, press and release the "P" button. See
Figure 30
DOWN FORCE
LED #2 and #3
should be blinking.
Press and release the "+" or "-" button once. The
illuminated LEDs around the display will display the current force setting. By pressing the
"+" or "-” key, the force can be increased (+) or decreased (-). The force should be set as
low as possible. Once the desired force is selected, press and release the "P" button. See
Figure 31
IMPORTANT MAINTENANCE & SAFETY INSTRUCTIONS
Monthly,
check the opener's down cycle safety reverse. The door must reverse when it
contacts a 1 1/2" (38) high object (or a 2X4 board laid flat) on the floor, in line with the door
opener. A closing door must also reverse if the photo eyes are interrupted. See Steps 12,13.
Always
keep the moving door in sight and away from people and objects until it is
completely closed. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR.
NEVER
go under a stopped, partially open door.
Do not allow children
to operate or play with the garage door controls. Keep the remote
control away from children.
SAVE THESE IMPORTANT INSTRUCTIONS
SAVE THESE IMPORTANT INSTRUCTIONS
If the Safety Reverse
or any other part of the garage door and opener system do not work
properly, or if you do not understand, call a trained Martin Door Dealer.
The emergency release
should only be used when garage door is in the closed position.
Weak or broken springs may cause door to fall, if released in the open position, increasing
the risk of severe injury or death. Use caution when using the release with door open.
Monthly
visually check lift cables, spring assembly, hardware, etc. for wear and stability.
KEEP GARAGE DOOR PROPERLY BALANCED.
See garage door owner’s manual. An
improperly balanced door increases the risk of severe injury or death. Call a trained Martin
Door Dealer to repair lift cables, spring assemblies and other hardware.
COPYRIGHT © 2003 MARTIN DOOR
15
UP FORCE
UP FORCE
FIGURE 30
END PROGRAMMING
FIGURE 29
FIGURE 31
DOWN FORCE
!
TO REDUCE THE RISK OF SEVERE INJURY OR
DEATH, READ AND FOLLOW ALL INSTRUCTIONS
TO REDUCE THE RISK OF SEVERE INJURY OR
DEATH, READ AND FOLLOW ALL INSTRUCTIONS
