6
Setup
S
ETUP
3
The package includes the following items:
Destroyer or Punisher
IEC mains cable
Mounting bracket and hardware
User manual
Before starting to operate the unit you need to:
Install the halogen lamp (not included)
Fit a mains plug
Check voltage setting
Fit the mounting bracket
Rig the unit in its permanent site
WARNING! Always disconnect the unit from AC power before performing
any installation or service procedure.
I N S T A L L I N G T H E L A M P
See the specifications on page 16 for lamps that may be used in the Destroyer
X250 and Punisher X250. Do not install any other lamp.
Warning!
Allow the unit to cool for 15 minutes before handling.
1 Remove the 2 screws from the lamp access plate on the bottom of the unit.
2 Loosen the thumbscrew and pull back on the lamp socket/reflector assembly
until the assembly is free of its mounting plate. Remove the lamp assembly.
3 Hold the new lamp in a cloth to avoid contaminating it with oils from your
fingers. Press it squarely into the socket.
4 Hold the lamp assembly by the socket end, with the thumbscrew up. Slide the
thumbscrew into the notch on the mounting plate. Align the holes in the
assembly with the guide screws on the mounting plate and press the lamp
assembly flush against the mounting plate. Tighten the thumbscrew.
5 Replace the lamp access cover.
35000035C.FM Page 6 Wednesday, January 3, 2001 9:33 AM
