User guide
17
display address should now be correctly matched to its position in the physical installation. De-activate the
test pattern for that panel and continue checking any remaining panels.
Note! Physical panels in the installation must have the correct display address for their position in
the physical installation. You cannot give a panel a correct address by moving it with the mouse to a
new location in the on-screen installation – doing this will not change the display address of the
panel, it will simply move the part of the video image displayed by that panel to the wrong position in
the physical installation. If a physical panel has an incorrect display address for its position in the
installation, you must either (a) enter
Device Properties
for that panel and set its display address to
the correct number as described above, or (b) manually set the correct display address for that panel
using the control buttons on the back of the panel base.
3. Once you have given correct display addresses to panels in the
Configured Devices
window, repeat this
process for any panels in the
Discovered Devices
list. See Figure 15. Click on the panel name (arrowed)
to open its
Device Properties
, set the panel to display a test pattern (arrowed), give the panel the correct
display address (arrowed) for its position in the physical display, then de-activate the test pattern. Each
time you give a correct display address to a detected panel, it will appear in the
Configured Devices
list
Figure 14: Device Properties for Discovered Devices
