Service
29
System and hardware status information
Viewing directly on the monitor
To view system and hardware status
information on the monitor:
1. See Figure 27. Click on the
Hardware
Settings
button (arrowed).
2. See Figure 28. Click on the blue question
mark button in the bottom left of the
Hardware Settings
window.
3. See Figure 30. The P3-100’s firmware
version, serial number, uptime (resets at
power on) and hardware temperatures are
displayed in a pop-up window.
Remote viewing via
network
The P3-100 also features a
built-in webserver that allows
remote access to status
information via a network.
To access status info over a
network:
1. Plug a network cable into
Ethernet port 1 on the
P3-100’s rear panel to
connect the P3-100 to the
network.
2. See Figure 27 on page 27.
Click on the
Hardware
Settings
button (arrowed).
3. See Figure 28 on page 27. If
using DHCP, make sure the
Use DHCP
checkbox under
Network Settings
is
checked. Otherwise enter
static IP address, subnet
mask and gateway details.
4. Start a web browser on a
PC on the network and open
the address
http://
followed
by the IP address shown
under
Web Server
in the
Hardware Settings
window.
This connects you to the
P3-100 and opens a
webpage containing status
information for the P3-100
and all connected panels
(see Figure 31).
Figure 30: System and hardware info
Figure 31: System info via network
