© Martin Engineering GmbH
6
M3814UK-03/16
Introduction
2.2
Appropriate Use
MARTIN
®
(PD) QC
™
#1 HD MT primary cleaner with
TC (Tungsten carbide) inserts is used only for cleaning conveyor
belts directly on the head pulley. It can have a maximum belt width
of 2,400 mm or reach a maximum conveying speed up to 5 m/sec..
It cannot be used with conveyor belts having mechanical splices
and/or surface damage.
Any other use of this product is deemed to be inappropriate. If you
wish to use the product for any other purpose, please contact Martin
Engineering Customer Service. We will be happy to assist you with
product configuration.
2.2.1
Conveyor belt systems with open transfer systems
This installation manual describes the installation on a conveyor belt
system with an encapsulated delivery system. For the installation on
open delivery systems different MARTIN
®
installation consoles can
be used.
If installation conditions prove to be difficult, as is the case with im-
passable static components, or using the head drum as the tension
point, Martin Engineering or a representative can help with the posi-
tioning or find customised solutions.
2.2.2
Use in EX-protection areas
Under certain circumstances, this product can also be used in po-
tentially explosive areas. Contact Martin Engineering for more infor-
mation on use in potentially explosive areas.
The use of the cleaner in a device protection category that is higher
than that specified or under operating conditions other than those
specified by Martin Engineering is not permissible or may be done
only if Martin Engineering has granted its approval.
