© Martin Engineering GmbH
7
M3814UK-03/16
Introduction
2.2.3
Operating limits of this product
The use of the product mentioned here is allowed only within the
specified specifications. Using it in a higher than specified equip-
ment category or under operating conditions other than those
named and previously specified by Martin Engineering is considered
to be inappropriate use and can only be carried out if approved by
Martin Engineering.
If the product mentioned here is to be used for a different purpose,
then Martin Engineering or a representative can help with the prod-
uct configuration.
2.3
Safety in the Workplace
2.3.1
Safety instructions, safety in the workplace
This installation manual must be read through in full prior to com-
mencing work on the product or the customer's conveyor belt.
The operator must ensure that all installation, inspections, and main-
tenance tasks are carried out exclusively by authorised experts.
All work on conveyor belts and their accessories must always be
carried out only when the system is at a standstill. It is essential that
the procedures described in the relevant installation manual which
explain how to shut down the conveyor system are followed.
Upon completion of work, all safety equipment and protective
guards must be reinstalled and put back into operation.
Prior to commissioning, installation must be completed. Before the
conveyor belt can be put back into operation, the flawless execution
of all steps should be checked and verified. All notes on installation
and commissioning of the product should be observed.
