© Martin Engineering GmbH
19
M3504UK-10/15
Installation
5.2.7
Install locking sleeve
In case of a spring tensioner being only installed on one side, a lock-
ing sleeve is installed on the opposite side of the chute wall so that
the primary cleaner cannot move sideways.
1. Slide the stop sleeve (1,Fig.8) over the mainframe tube (2,
Fig.8) of the primary cleaner on the far side of the chute wall.
2. Slide the stop sleeve (1, Fig.8) until it lies against the rubber
bushing (3, Fig.8).
3. Tighten the clamp screws (4, Fig.8).
5.2.8
Tensioning the primary cleaner blade
Observe the instructions on installing the tensioner in the respective
installation manual of the tensioner being used.
Fig. 8: Installation of the locking sleeve
CAUTION! DANGER OF DAMAGE!
Damage may occur if the tension of the conveyor belt cleaner on
the conveyor belt is too high or uneven.
Only tension the conveyor belt scraper according to the guidelines
and with dual spring tensioners, ensure even tension.
1
3
2
4