© Martin Engineering GmbH
21
M3504UK-10/15
Installation
5. Check the belt cleaner for the following points:
• Wear and tear: a little wear and tear is normal, as soon as
the cleaner blades have got adjusted to the contour of the
conveyor belt, this stops happening.
• Bulk material accumulation: No bulk material should get
accumulated between the cleaner blades and the return
side.
6. If the wear and tear or bulk material accumulation is excessive
or other problems occur, refer to the information in section 5.4
„Installation Check-list“ or section 7 „Troubleshooting“.
5.4
Installation - Check-list
If the test run of the secondary cleaner was not as expected, then
the „Installation Check-list“ table could help to find and solve the
problem. If other problems persist, refer to and follow section 7
„Troubleshooting“.:
Installation - Check-list
The primary cleaner should be installed on both sides according
to the measurements in section 5.2 onwards.
The primary cleaner is installed in the correct position and all
critical installation measurements are adhered to.
The blades must be installed in the centre of the conveyor belt
and/or head pulley.
Tab. 3: Installation - Check-list
