-1-
1. Safety and EMC Instructions
Please read carefully the following user manual and the
safety instructions before installing or operating the unit!
1.1 Installation
★
See installation instructions before connecting to mains power.
★
Condensation may occur if the UPS is moving directly from a cold
to a warm environment. The UPS must be absolutely dry before
being installation. It is recommended to have an acclimatization
time at least two hours.
★
Do not install the UPS near water or in damp environment.
★
Do not install the UPS where it would be exposed to direct sunlight
or near heat.
★
Do not connect appliances or items of equipment which would
overload the UPS (e.g. laser printers, etc.) to the UPS output.
★
Place cables properly to avoid someone treaded or tripped over
them.
★
Assure to connect with the earth reliably.
★
Connect the UPS only to a socket outlet which is earthed
shockproof type.
★
The building wiring socket outlet (shockproof socket outlet) must
be easily accessible to close to the UPS.
★
With the installation of the equipment, the sum of the leakage
current of the UPS and the connected load does not exceed
3.5mA.
★
Do not block ventilation openings on the UPS’s housing. Ensure
the air vents on the front, side and rear of the UPS are not blocked.
Recommended at least 25cm of space on each side. The air flow
diagram is shown as below:
Summary of Contents for Tacoma HT 1K-3KVA
