8
Step 6: Turn on the UPS
Press the ON/Mute button on the front panel for two seconds to power on the UPS.
Note
: The battery charges fully during the first five h ours of normal operation. Do not expect full
battery run capability during this initial charge period.
Step 8: Install software
For optimal computer system protection, install UPS monitoring software to fully configure UPS
shutdown. Use supplied RS-232 or USB communication cable to connect RS-232/USB port of UPS
and RS-232/USB port of PC. Then, follow steps below to download and install monitoring
software:
1. Insert the included installation CD into CD-ROM drive and then follow the on-screen
instructions to proceed software installation. If there no screen shows 1 minute after inserting
the CD, please execute setup.exe file for initiating software installation.
2. Follow the on-screen instructions to install the software.
3. When your computer restarts, the monitoring software will appear as an orange plug icon
located in the system tray, near the clock.
2-5 Battery Replacement
When the icons of
and
are flashing in LCD display and alarm is sounding every 2
seconds,
it’s time to replace b
atteries. Contact your service representative to replace batteries.
Do not disconnect battery connectors under load
If you prefer to remove input power to change
the batteries, press the OFF button on the front panel for two seconds to power off the UPS and
switch off utility power where the UPS is connected.
NOTE 1 :
DO NOT DISCONNECT the batteries while the UPS is in Battery mode.
NOTE 2 :
A small amount of arcing may occur when connecting the internal batteries. This is
normal condition and no harm for personnel. Connect the cables quickly and firmly.
NOTE 3 :
This UPS is equipped with internal batteries and only service person can replace the
batteries.
NOTE 4 :
Upon battery disconnection, equipment is not protected from power outages.
CAUTION!!
Consider all warnings, cautions, and notes before replacing batteries.
RT UPS
Step 1
Step 2
Step 3
It’s in closed status for UPS
normal operation as default.
To activate EPO
function, remove
these two screws.