―
US-9
―
Assembly
Assembling Engine and Drive
shaft
Assembly
The driveshaft, clutch drum housing and gearcase are
assembled. Attach the clutch drum housing to the
engine using the four M5 x 20 screws supplied with the
unit.
Loop Handle Installation
The loop handle kit contains a package of four screws
and nuts, a rubber sleeve and the bottom clamp for the
loop handle.
1. Slip the rubber sleeve around the shaft approxi-
mately 9 inches (22.8cm) from the end of the stop
switch/throttle trigger assembly.
2. Rotate the rubber sleeve so the split is to one side.
3. Place the loop handle and the bottom clamp over
the rubber sleeve.
4. Install the four screws and nuts. Leave the screws
fingertight.
5. Reposition the loop handle up or down the driveshaft
to the most comfortable position, but no closer than 9
inches (22.8 cm) from the end of the stop switch.
6. Tighten the screws and nuts.
Connecting Stop Switch Wires
Loop Handle
Screw (4)
Bottom Clamp
Nut (4)
Rubber Sleeve
Summary of Contents for B23C
Page 70: ...FR 25 P riod d entretien...
Page 71: ......
