Fuel Mixture Chart
Starting And Stopping
Before Starting The Engine
1. Fill the fuel tank as instructed in the Before Operation
section of this manual (page US-1
1
).
2. Rest the Trimmer on the ground.
3. Make sure the cutting attachment is clear of any
broken glass, nails, wire, rocks or other debris.
4. Keep all bystanders, children and animals away
from the working area.
Mixing Instructions
IMPORTANT: Never mix gasoline and oil
directly in the Trimmer fuel tank.
1. Always mix fuel and oil in a clean container
approved for gasoline.
2. Mark the container to identify it as fuel mix for
the Trimmer.
3. Use regular unleaded gasoline and fill the container
Cold Starting Procedure
with half the required amount of gasoline.
This Trimmer is equipped with a fuel primer and a choke
4. Pour the correct amount of oil into the container
system. To start a “cold” engine properly, perform the
following procedure:
then add the remaining amount of gasoline.
5. Close the container tightly and shake it momentarily
1. Pump the primer bulb at the bottom of the carbu-
to evenly mix the oil and the gasoline before
retor until fuel can be seen flowing through the
filling the fuel tank on the Trimmer.
fuel return line to the fuel tank. (Flowing fuel should be
almost clear, not foamy or full of bubbles.)
6. When refilling the Trimmer fuel tank, clean
around the fuel tank cap to prevent dirt and debris
2. Move the choke lever to the closed (
) position
from entering the tank during cap removal.
and move the stop switch to the “ON” position.
7. Always shake the premix fuel container momen-
3. Lock the throttle trigger in the fast-idle start
tarily before filling the fuel tank.
position, then pull the starter grip.
8. Always use a spout or funnel when fueling to
reduce fuel spillage.
9. Fill the tank only to within 1/4-1/2 inch (6 mm-13
mm) from the top of the tank. Avoid filling to the
top of the tank filler neck.
―
US - 1
3
―
Summary of Contents for B23C
Page 70: ...FR 25 P riod d entretien...
Page 71: ......
