If the engine fails to start after you follow the
CAUTION
above procedures, contact an authorized
After the engine starts, squeeze and release the
throttle trigger to return it to the idle position, then
move the choke lever to the open (
) position.
If the engine stops running before you move the
choke lever to the open (
) position:
Go ahead and open the choke, pull the starter grip with
the throttle tigger positioned at Fast-idle position.
Hot Restart
To start an engine that is already warmed up (hot
restart), or if the ambient temperature exceeds 68°F
(20°C):
1. Pump the primer bulb at the bottom of the car-
buretor until fuel can be seen flowing through the
fuel return line to the fuel tank.
2. Move the choke lever to the open (
) position
and move the stop switch to the “ON” position.
3. Leave the throttle trigger in the idle position and
pull the starter grip.
4. If the engine fails to start after three to four pulls,
follow the instruction in the Cold Starting
Procedure section (this page).
MARUYAMA dealer.
• Do not pull the Starter rope all the way out.
To Stop The Engine:
WARNING
• Do not disassemble the Starter.
Please ask for an authorized MARUYAMA
1. Release the throttle trigger.
2. Slide the stop switch to the “STOP” position.
service dealer.
Operation
WARNING
Operating Position
Before using the Trimmer, check the following:
1. Make sure the Holding Tool (3mm
hexagonal wrench
)
has been
removed from the gearcase and boss adapter
before
you start the engine.
POTENTIAL HAZARD
・
Foreign objects can be thrown by String Trimmer.
WHAT CAN HAPPEN
・
Contact with thrown objects can cause personal
injury.
HOW TO AVOID THE HAZARD
・
Never operate the String Trimmer without the
guard.
CAUTION
• Read the Safety instructions on page US-6
concerning proper use of the String Trimmer.
―
US - 1
4
―
Summary of Contents for B23C
Page 70: ...FR 25 P riod d entretien...
Page 71: ......
