19
6
How to Travel/Transport
◼
How to Start/Stop the Engine
(1) How to Start
Warning
⚫
To ensure safety, apply the parking brake, put
the auxiliary shift lever in the
“N – Start”
position and put the HST lever in the
“N”
position before starting the engine.
⚫
Provide sufficient ventilation when starting the
engine indoors. Failure to do so may cause
exhaust gas poisoning.
Caution
⚫
Before starting the engine, check the
surrounding areas to ensure safety and also
confirm that the cover is closed.
Caution
⚫
Once the engine is started, do not apply load but
simply warm up the engine for approx. 5 minutes
so as to spread oil to each metal area fully. Take
note that, if load is applied immediately after the
engine is started, breakdown may occur due to
seizure, damage, etc.
Start the engine from the driver seat after giving a cue
to people around the machine and also checking the
surroundings to ensure safety.
[1] Apply the parking brake.
[2] Put the HST lever in the
“N” position and auxiliary
shift lever in the
“N – Start” position.
[3] Insert the ignition key in the key switch.
[4] Tilt the throttle lever forward for
“low speed”
operation.
[5] Turn the key switch to the
“GL” position and keep it
in this position until the glow lamp turns off.
[6] Turn the key switch key to the
“ST” position. Once
the engine has started, release the switch. The key
switch will automatically return to the
“ON” position.
[7] Check each warning lamp to confirm that the engine
is normal. If any warning lamp is on, immediately
stop the engine and take an appropriate measure. If
you hear abnormal noise different from what you
hear every day, stop the engine and investigate the
cause. If the cause cannot be identified, contact
your Maruyama dealer.
[8] Return the throttle lever to the
“low speed” side, and
warm up the engine for 5 minutes before
commencing work.
Warning
⚫
Warm up the engine outdoors to prevent
exhaust gas poisoning.
Caution
⚫
Be sure to apply the parking brake and keep
your eyes on the machine while the engine is
warming up.
⚫
If the engine does not start with the first try on a
cold day, etc., repeat preheating and try starting
the engine. Do not turn the cell motor for more
than 10 to 15 seconds. Before restarting the
engine, wait for 30 seconds to restore the
battery voltage.
⚫
Do not turn the key switch to the
“ST” position
while the engine is turning.
⚫
The engine is still cold immediately after the
start, so do not rev up the engine or raise the
engine speed unnecessarily. It may cause
breakdown.
⚫
Check the exhaust condition for abnormality
and if any abnormality is found, immediately
stop the engine and change fuel or oil, or
contact your Maruyama dealer.
(2) How to Stop
[1] Push the throttle lever forward to lower the engine
speed.
[2] Let the engine operate at the low speed for approx.
5 minutes to cool down.
[3] Turn the key switch to the
“OFF” position.
(3) Break-In Operation
Caution
⚫
How the machine is handled when new (during
initial 50 hours) affects the life and performance
of the machine. In particular, pay attention to
the items specified below during this period.
[1] Fully warm up the engine before commencing work.
[2] Change oils according the Oil Change Table after
initial 50 hours of operation. (Refer to P. **.)
