— US-10 —
Assembly
Assembling Engine and Shaft
Assembly
Attach the clutch drum housing to the engine using the
four screws supplied with the unit.
Connecting Stop Switch Wires
1. Install the plastic tube (packed with the shaft
assembly) around the throttle cable and stop
switch wires.
2. Loosen the knob and remove the air filter cover to
access the stop switch wires.
3. Plug the stop switch wires into the matching
connectors from the engine. Note that wire
polarity is not important.
Connecting Throttle Cable
1. With the air filter cover removed, insert the throttle
cable through the cable adjuster sleeve on the
carburetor bracket. Make sure the end of the cable
housing is seated positively in the sleeve.
2. Position the slotted fitting on the carburetor so the
recessed hole for the lug is away from the cable
adjuster sleeve.
3. Rotate the carburetor throttle cam and slip the
throttle cable through the slot in the slotted fitting,
making sure the cable lug drops into the recessed
hole.
4. Operate the throttle trigger a few times to make
sure that it works rightly.
5. Adjust the cable adjuster sleeve so the stop on the
carburetor throttle cam contacts the idle speed
adjustment screw and the cable position keep
1-2mm play between cable lug and slotted fittings
when the throttle trigger is fully depressed.
Engine
Screw (4)
Clutch Drum Housing
Air Filter Cover
Knob
Matching Connectors
Stop Switch Wires
Matching Connectors
Shaft Grip
Plastic Tube
Stop Switch Wires
Throttle Cable
Throttle Cable Housing
Cable Adjuster Sleeve
Locknut
Throttle Cable
Slotted Fitting
Recessed Hole
Cable
Lug
Carburetor Bracket
Cable Adjuster
Sleeve
Throttle Stop/Idle Speed
Adjuster Screw Bracket
Carburetor Throttle Cam
Slotted Fitting
Idle Speed
Adjustment Screw
