＿
13
＿
General Cleaning and Tightening
The MARUYAMA Multi-Cutter will provide maximum performance for many, many hours if it is maintained
properly. Good maintenance includes regular checking of all fasteners for correct tightness, and cleaning
the entire machine.
WARNING
POTENTIAL HAZARD
・
When engine is running, attached tool and other parts are moving.
WHAT CAN HAPPEN
・
Contact with moving tool or other moving parts could cause serious personal injury or death.
HOW TO AVOID THE HAZARD
・
Always turn off your Multi-Cutter before you clean or perform any maintenance on it.
Storage
For long term storage of the Multi-Cutter:
1. Empty the fuel tank into a suitable fuel storage container.
2. Run the engine to remove any fuel that may remain in the carburetor.
3. Perform all regular maintenance procedures and any needed repairs.
4. Remove the spark plug and squirt a very small amount of engine oil into the cylinder.
5. Pull the starter grip once.
6. Slowly pull the starter grip to bring the piston to the top of the cylinder (TDC).
7. Reinstall the spark plug.
8. Store the Multi-Cutter in a dry place away from excessive heat, sparks or open flame.
CAUTION
POTENTIAL HAZARD
・
Oil may squirt out of the spark plug opening when you pull
the starter grip.
WHAT CAN HAPPEN
・
Oil can cause eye injuries.
HOW TO AVOID THE HAZARD
・
Protect your eyes and keep your face away from the spark
plug opening.
