37
37
37
37
11
11
Precautions for Spraying
Warning
Caution
12
12
Chemical Preparation
Warning
[1] Prepare only the required amount using a
dedicated container.
[2] In the case of water-dispersible powder, dilute a
small amount with water in a bucket, etc., and
put the prepared solution in the main tank
(chemical tank). Put chemical after water.
[3] Confirm that the spray cock is in the “Close”
position.
[4] Turn the PTO of the tractor at 540 min
-1
.
[5] Turn the pressure adjustment dial to adjust the
pressure to 2.0MPa.
[6] Run the PTO several minutes in this condition
to fully agitate the chemical.
[7] If spreading agent is used, follow the instruction
manual that came with the spreading agent.
13
13
Spray Method
Caution
[1] Move the machine to the spray location.
[2] Stop the machine just before the position where
you want to start spraying.
[3] Confirm that the feed valve is open.
[4] Make sure the position of the fan transmission
lever corresponds to the rotating direction.
[5] Set the tractor engine to low speed and turn the
PTO.
[6] Operate the throttle and adjust the PTO speed
to 540 min
-1
.
[7] Turn the pressure adjustment dial to adjust the
pressure to a required level for work between
1.0 and 2.0 MPa.
[8] Put the shift lever on the tractor in the required
position and start driving.
[9] After arriving at the desired starting position, set
the spray cock in the “Open” position and start
spraying.
Caution
●
Before spraying, adjust the axle and hitch directions until the universal joint becomes level.
If the angle of the universal joint is too sharp, the spray pump may malfunction.
●
The person performing spraying should
wear protective gears for agrichemical
spraying (such as a pest control mask,
protective glasses, boots, rubber gloves
and waterproof protective cloth, etc.) to
prevent the chemical from coming in direct
contact with the body.
●
Keep only the required amount of spray
agent in the main tank (chemical tank) to
prevent leftovers.
●
Chemical spouts out from the nozzle.
Do not let anyone come near the nozzle
during spraying.
●
Carefully read the instruction manual of the
applicable chemical and use the chemical
correctly.
●
Prepare chemical with the fan transmission
in the stop (neutral) position.
●
If the PTO is connected abruptly when the
tractor engine is running at high speed,
the spray pump and fan transmission may
malfunction. Be sure to keep the engine
speed low when turning the PTO.
●
Use the PTO of the tractor at a speed of
540 min
-1
. If the PTO speed is too high or
too low, uneven spraying or spray pump
malfunction may result.
●
Do not run the spray pump continuously
for 1 minute or more after chemical has run
out. The spray pump may malfunction.
Summary of Contents for SSD600
