If You Do Need Service
If you do need service, contact your dealer or the
manufacturer. In any correspondence, refer to the
model number and serial number of your unit
which is located on the upper left hand side of the
wall liner. Retain you proof of purchase. You may
want to record these numbers in the space below.
How to Obtain Service
Your beverage center requires little service because
the best and most up to date materials, equipment
and quality methods are employed throughout the
manufacturing process.
If trouble occurs during normal operation, first
check the troubleshooting chart on the opposite
page to see if any of these simple steps may correct
the problem. If service becomes necessary:
1. If the product is within the first year warranty
period, please call Marvel Customer Service
at 800-428-6644 for directions on how to
obtain warranty coverage in your area.
2. If the product is outside of the first year
warranty period, Marvel Customer Service
can provide recommendations of service
centers in your area. A listing of authorized
service centers is also available at
www.marvelindustries.com under the service
and support option.
3. In all correspondence regarding service, be
sure to give the model number, serial number
and proof of purchase.
4. Try to have information or description of the
nature of the problem, how long the unit has
been running, the room temperature, water
temperatures, and any additional information
that may be helpful in quickly solving the
problem.
O B TA I N I N G S E RV I C E
8
For Your Records
Date of purchase
Dealer’s Name
Dealer’s Address
Dealer’s City
Dealer’s State
Zip
Appliance Serial Number
Model Number
Date Warranty Card Sent (Must be within 10 Days of Purchase)
figure 1
Select Location
The proper location will ensure peak performance
of your appliance. Choose a location where the
unit will be out of direct sunlight and away from
heat sources. Best performance will be maintained
when installed within the following parameters:
Ideal Ambient Temperature Range
Built-in
65°– 80°F
Free-Standing
65°– 90°F
Cabinet Clearance
Ventilation is required from the bottom front section
of the unit. Keep this area open and clear of any
obstructions.
I N S TA L L AT I O N
3
figure 2
Electrical Connection
Use nominal 115 volt, 60 cycle AC only. DO NOT
USE AN EXTENSION CORD.
Grounding Method
This product is factory equipped with a power
supply cord that has a three-pronged, grounded
plug. It must be plugged into a mating grounding
type receptacle in accordance with the National
Electrical Code and applicable local codes and
ordinances (see figure 1). If the circuit does not
have a grounding type receptacle, it is the
responsibility and obligation of the customer to
exchange the existing receptacle in accordance
with the National Electrical Code and applicable
local codes and ordinances. The third ground
prong should not, under any circumstances, be cut
or removed. (See figure 2) All U.L. listed
refrigerated products are equipped with this type of
plug.
