Marvel MPWC415, Owner'S Manual

INSTALLING THE ANTI TIP DEVICE

Step by step instructions for locating the po-

sition of the bracket:

1) Decide where you want to place the beverage center. 

Slide it into place, being careful not to damage the floor, 

leaving 1" (2.5 cm) of clearance from the rear wall to allow 

room for the anti-tip bracket.

2) Raise the rear leveling legs approximately 

1

⁄

4

" (6 mm) to 

allow engagement with the anti-tip bracket. Level the unit 

by adjusting all the leveling legs as required. Turning the 

leveling leg counterclockwise will raise the unit and clock-

wise will lower the unit.

3) Make sure the beverage center is in the desired loca-

tion, then mark on the floor the rear and side corner of the 

cabinet where the anti-tip bracket will be installed. If the 

installation does not allow marking the rear corner of the 

cabinet, then make temporary lines on the floor marking 

the front corner of the cabinet, excluding the door. Slide the 

beverage center out of the way. From the temporary line 

extend the sidewall line back 21

1

⁄

2

" (54.6 cm) as shown in 

Figure 15. 

4) Align the anti-tip bracket to the marks on the floor so 

the side of the bracket lines up with the side of the cabinet 

mark, and the "V" notches on the anti-tip bracket line up 

with the end of the 21

1

⁄

2

" (54.6 cm) line (Rear of cabinet 

line).

5) Fasten the anti-tip bracket to the floor using the supplied 

screw. (See Figure 15).

6) Slide the cabinet back into position, making sure the rear 

cabinet leveling leg slides under the anti-tip bracket engag-

ing the slot.

Front of cabinet

Figure 14

21

1

⁄

2

"

(54.6 cm)

Anti-Tip

Bracket

Leveling Leg

Bottom View of

Beverage 

Center

Floor Mount Installation

The anti-tip bracket is to be located on the floor in the left 

or right rear corner of the wine cellar as shown in Figure 14.

!

WARNING

•  ALL APPLIANCES CAN TIP 

RESULTING IN INJURY.

•  INSTALL THE ANTI-TIP 

BRACKET PACKED WITH 

THE APPLIANCE.

•  FOLLOW THE INSTRUC-

TIONS BELOW

!

CAUTION

NOTE

Any finished flooring should be protected with appropriate 

material to avoid damage when moving the unit.

If installing on a concrete floor, concrete fasteners are 

required, (not included with the anti-tip kit).

Anti-Tip Device

!

WARNING

If your beverage center is not located under a counter 

top (free standing), you must use an anti-tip device 

installed as per these instructions. If the beverage 

center is removed from its location for any reason, 

make sure that the device is properly engaged with 

the anti-tip bracket when you push the beverage 

center back into the original location. If the device is 

not properly engaged, there is a risk of the beverage 

center tipping over, with the potential for property dam-

age or personal injury. 

11