11
9.2 Calibrating the Gyro
After pairing, short press the
gyroscope calibration button of
the remote control, the remote
control will make a beep, and the
LED lights of the drone will flash
quickly for 2 seconds. At this point,
the drone is reset to factory settings
and is ready to fly.
(4). Slowly push the left joystick of the
transmitter up to the top and transmitter
will beep once and then pull down to
the bottom and transmitter will beep
once again. After pairing, the power
indicator of the remote control will be
solid, and the LED lights of the drone
will appear "flickering".
Up
Down
(3). Place the drone on a flat and level
surface with the head forward and
the tail facing towards the operator.
HEAD
Short Press