Fit the protection cap (
1
).
Assembling: Assembling the top left cap
Screw the lock cap (
2
) down on the rod of the ETA cartridge without tightening being very careful not to
damage the O-ring.
Using the 10mm and 21mm spanners, tighten locknut (
6
) on cap (
2
) to the recommended tightening
torque (
6 Nm ± 1
).
With the 21mm socket spanner, tighten the lock cap (
2
) on the steering crown to the recommended
tightening torque (
10 Nm ± 1
).
Fit the ETA control knob (
5
) and screw (
4
).
Using a 2mm Allen wrench, tighten the knob fixing screw (
4
) to the recommended tightening torque (
2
Nm ± 0.5
).
© Marzocchi Suspension
2005
-
MX Comp ETA
