7
Steps of start and stop
Before starting the engine, make sure the drive lever at the neutral position, the
vibrating rod is in the OFF position, the parking brake is in the ON position.
1. Open the fuel switch on the engine
。
2. Move throttle handle of operating lever to the start position
3. Start engine- See the engine user's manual on how to start
4. Move the throttle lever to lower and let the engine idle a few minutes, warm up the
engine.
5. After the engine warm-up, the machine can begin the operation.
6. Push the throttle lever to the high-speed "H" position fastly to prevent damage to the
clutch. "Full throttle" position the machine is pre-set by the manufacturer, which make the
machine to achieve the best performance. Do not change this setting, because this will
lead to early wear and tear, and the warranty on the engine and the machine will
automatically lapse.
7. Push the parking brake lever to the right, making the separation
（
graph 1
）。
graph 1
Remark:
Due to neglect the parking brake separation, and then attempt to drive the machine
forward or backward would seriously damage the parking brake mechanism and drive
mechanism.
Improper operation can lead to hazards. Before any repair and maintenance, first
read and understand this chapter.
Caution
