1
CONTENTS
Ⅰ
RULES FOR SAFE OPERATION
General Safety …………………………………….1-2
Diamond Blade Safety ……………………….……..2
Cutter Transportation Safety ………………….……2
Emergencies …………………………………………3
Maintenance Safety …………………………………3
Ⅱ
OPERATION
Introduction ……………………………………….….3
Determining the Right Machine ……………………3
Operating Principle ………………………………….3
Delivery Checks ……………………………………..3
Installing Blade ………………………………………4
Type of Cutting ………………………………………4
Before Starting …………………………………….…4
To Start Cutting ………………………………………4
Cutting ………………………………………………...5
Belts & Pulleys ……………………………………….5
Dry Cutting ……………………………………………5
Ⅲ
MAINTENANCE
Troubleshooting ……………………………………6-7
Ⅳ
LUBRICATION AND SERVICE
…………….…8
Ⅴ
SPECIFICATION
………………………………..8
Ⅵ
WARRANTY
…………………………………..
8
Ⅶ
REPLACEMENT PARTS LIST
……………9-12
Ⅰ
RULES FOR SAFE OPERATION
WARNING:
Failure to follow instructions in this manual may lead to
serious injury or even death! This equipment is to be
operated by trained and qualified personnel only! This
equipment is for industrial use only.
The following safety guidelines should always be used
when operating the MASALTA concrete Cutters:
GENERAL SAFETY
■
DO NOT
operate or service this equipment before
reading the entire manual.
■
This equipment should not be operated by persons
under 18 years of age.
■
NEVER
operate this equipment without proper
protective clothing, shatterproof glasses, steel-toed
boots and other protective devices required by the job.
■
NEVER
operate this equipment when not feeling well
due to fatigue, illness or taking medicine.
■
NEVER
operate this equipment under the
influence or drugs or alcohol.
■
NEVER
use accessories or attachments,
which are not recommended by MASALTA
for this equipment. Damage to the
equipment and/or injury to user may result.
■
The manufacturer does not assume
responsibility for any accident due to
equipment modifications.
■
Whenever necessary, replace nameplate,
operation and safety decals when they
become difficult to read.
■
ALWAYS
check the machine for loosened
threads or bolts before starting.
■
NEVER
touch the hot exhaust manifold,
muffler or cylinder. Allow these parts to cool
before servicing engine or saw.
■
High Temperatures
– Allow the engine to
cool before adding fuel or performing
service and maintenance functions.
Contact with
hot
components can cause
serous bums.
■
The engine section of this cutter requires
an adequate free flow of cooling air.
NEVER
operate the cutter in any enclosed
or narrow area where free flow of the air is
restricted. If the air flow is restricted it will
cause serious damage to the saw or engine
and may cause injury to people. Remember
the cutter’s engine gives off
DEADLY
carbon monoxide gas.
■
ALWAYS
refuel in a well-ventilated area,
away from sparks and open flames.
■
ALWAYS
use extreme caution when
working with flammable liquids. When
refueling, stop the engine and allow it to
cool.
DO NOT
smoke around or near the
machine. Fire or explosion could result
from fuel vapors, or if fuel is spilled on a hot
engine.
■
NEVER
operate the cutter in an explosive
atmosphere or near combustible materials.
An explosion or fire could result causing
severe bodily harm or even death.
■
Topping-off to the
fuel
filler port is
dangerous, as it tends to spill fuel.
