H
G
J
I
K
U
cod. F07011720
14 - EN
4. Install PTO shaft to tractor.
For cat. I & II iMatch Quick Hitch Ø = 31.5 mm (1.24 inch)
IMPORTANT: Tiller MUST BE level front to rear.
• Engage the cardan shaft and check that it is perfectly
locked on the tractor PTO (G). Check that the guard
(H) is free to turn and fi x it with the relative latch at
both ends.(U)
NOTE: Fix the cardan shaft guard to the machine
by passing the chain into the hole (U) placed on the
mast plate, as showed on the picture.
5. Raise tiller.
6. Remove spring locking pin (K) from parking stand.
7. Slide parking stand (I) up along stand bracket (J) to
the bottom hole.
8. Fasten with spring locking pin (K).
9. Level tiller (See Leveling Tiller in the Operating Tiller
section).
10. Adjust sway chains on tractor lower draft arms to
minimize side way.
PTO shaft
The PTO shaft, supplied with the machine, is of standard
length.
When the PTO shaft is fully extended, the two tubes
must overlap by at least 6 inches (152.4 mm)(A). When
fully inserted, the minimum play must be 1.6 inch (40.6
mm) (B).
CAUTION: If the implement is used on an-
other tractor, always check that the guards
completely cover the rotating parts of the
PTO shaft.
INSTALLING
Summary of Contents for WEEKEND WARRIOR 6042
