5
166
Starting and Driving
Engine Remote Start Abort
Message on Instrument Cluster
The following messages will display
on the instrument cluster if the vehicle
fails to remote start or exits remote
start prematurely:
• "Remote Start Cancelled Door
Open".
• "Remote Start Cancelled Hood
Open".
• "Remote Start Cancelled Too Cold".
• "Remote Start Cancelled Liftgate
Open".
• "Remote Start Cancelled Fuel Low".
• "Remote Start Cancelled Time
Expired".
• "Remote Start Cancelled EPB Not
Available".
• "Remote Start Disabled Start Vehicle
to Reset".
The message on the instrument cluster
stays active as long as the ignition
device is in
ON
position.
To enter Remote Start Mode
NOTE:
On the key fob of vehicles with this
function, the approach lights button
is replaced by the remote start
button
.
Press and release the button
on
the key fob twice within five seconds.
The vehicle doors will lock, position
lights will flash and the horn will ring
twice (if the "Sound Horn with Remote
Start" function of the "Doors & Locks"
submenu is activate using the MIA
system, refer to “Functions of Settings
Menu on MIA” in section "Instruments
and Controls”). Then, the engine will
start and the vehicle will remain in the
"Remote Start" mode for a 15-minute
cycle.
NOTE:
• In case of an engine fault or low fuel
level, the vehicle will start and then
shut down in 10 seconds.
• The position lights will turn on and
remain lit during "Remote Start"
mode.
• For security reasons, power window
is disabled when the vehicle is in the
"Remote Start" mode.
• The engine can be started two
consecutive times (two 15-minute
cycles) with the key fob. However,
the ignition device must be cycled
to the
ON
position before you can
repeat the start sequence for a third
cycle.
To exit Remote Start Mode
without Driving the Vehicle
Press and release the button
one
time or allow the engine to run for the
entire 15 minute cycle.
NOTE:
To avoid unintentional shutdowns, the
system will disable the one time press
of the button
for two seconds
after receiving a valid "Remote Start"
request.
To exit Remote Start Mode and
Drive the Vehicle
Before the end of 15 minute cycle,
press and release the button
on
the key fob to unlock the doors and
disarm the vehicle security alarm.
Then, prior to the end of the 15
minute cycle, press and release the
START/STOP
button.
Summary of Contents for MC20 2022
