2
63
Understanding the Vehicle
NOTE:
If the garage door opening device
does not activate, press the button
a third time for two seconds and
then release it to complete the
programming/synchronization phase.
• To program the remaining two
HomeLink
®
buttons, repeat each step
for each remaining button.
DO NOT
erase the channels
.
Reprogramming a Single HomeLink
®
Button
To reprogram a channel that has been
previously trained, follow these steps:
• Place the ignition device to the
ON
position without starting the engine.
• Press and hold the desired HomeLink
®
button.
•
Without releasing the button
proceed with “Programming the
hand-held transmitters” from second
step and follow all remaining steps.
System with Devices Without
Rolling Code
Programming the Hand-held
Transmitters Manufactured before
1995
• Turn the ignition device to the
ON
position without starting the engine.
• Place the hand-held transmitter 1
to 3 inches (5 to 30 cm) away from
the HomeLink
®
button you wish to
program.
• Simultaneously press and hold both
buttons until the warning light starts
flashing quickly; then release both
buttons.
The quick flashing light indicates that
the channel with the new frequency
has been acquired and programmed
correctly by the HomeLink
®
system.
NOTE:
The distance necessary between the
portable hand-held transmitter and
the HomeLink
®
in the vehicle depends
on the system you wish to program.
Probably it will be necessary to try
several times. Upon every attempt,
keep the setting position for at least
15 seconds before trying again.
• Press and hold the programmed
HomeLink
®
button.
If the garage door opener/device
activates, programming is complete.
To program the remaining two
HomeLink
®
buttons, repeat each step
for each remaining button.
Do not
erase the channels.
Reprogramming a Single HomeLink
®
Button
To reprogram a channel that has been
previously trained, follow these steps:
• Place the ignition device to the
ON
position without starting the engine.
• Press and hold the desired HomeLink
®
button.
•
Without releasing the button
proceed with “Programming the
hand-held transmitters” from second
step and follow all remaining steps.
Using HomeLink
®
To operate, press and release the
programmed HomeLink
®
button.
Activation will now occur for the
programmed device (i.e., garage door
opener, gate operator, security system,
entry door lock, home/office lighting,
etc.). The hand-held transmitter of the
device may also be used at any time.
Security
It is advisable to erase all channels
before you sell or turn in your vehicle.
To erase the channels press and hold
the two outside HomeLink
®
buttons (I
and III) until the warning light starts
flashing (after approximately 20
seconds).
The HomeLink
®
Universal Transceiver
is disabled when the vehicle security
Summary of Contents for MC20 2022
