Mash SIDE FORCE 445cc, User Manual

42

43

1

1

2

2

3

3

Back to summary

Pression Side Force : Avant - 2,5 bar / Arrière et panier - 2,5 bar

Adjusting the transmission chain

To adjust:

1. Secure the motorcycle on its side stand or center stand (if equipped).

2. Loosen the nut on the rear wheel axle.

3. Loosen the lock nut.

4. Turn the adjustment bolt left or right to achieve the desired adjustment. 

1.Adjustment bolt

2.Lock nut

3. Rear wheel axle nut 

Note: When installing a new chain, it is 

necessary to check the pinion and crown. It 

is advisable to replace the chain kit.

The tension of the drive chain should be 

adjusted every 1000 km so that the play is 

between 20 and 30 mm. 

 Caution

The closed (rounded) part of the chain 

quick release clip should face the direction 

of chain rotation. 

1.  Quick chain clip

2. Direction of rotation 

Cleaning and lubricating the drive chain

The accumulation of dirt on the drive chain can worsen its wear and that of the 

sprockets. It is therefore strongly recommended to clean the chain every 1000 km 

using a cleaning solvent, then grease it with a special lubricant or engine oil.

Reference: IPONE: Chain Cleaner / X-TREM Chain Road. 

Tires 

Check the tire pressure and their tread after the first 1000 km, then every 3000 

km. In addition to periodic checks, get in the habit of checking tire pressure from 

time to time to prolong tire life and ensure maximum safety.

Tire pressure 

Insufficient pressure can worsen tire wear and affect vehicle stability: in particular, 

changes of direction can be more difficult. Conversely, excessive pressure, by reducing 

the contact surface between the tires and the road, increases the risk of skidding or 

even loss of control of the vehicle. Therefore, it is necessary for the tire pressure to 

remain within the specified limits. The tire pressure should be adjusted when cold, 

before driving. 

Tread Sculptures

Riding a side car with worn tires compromises its stability and comes with an 

increased risk of loss of control. If the tread depth of the front wheel is not sufficient, 

it is advisable to have the tire replaced. This operation is also necessary for the rear 

tire if the depth of the rear wheel tread is not sufficient. 

 Warning

As the use of tires other than the standard models can cause problems, 

it is strongly recommended that you use tires identical to the original ones. 

Compliance with the recommended tire inflation pressure is essential, it directly 

determines the performance of the vehicle and driving safety. Check tire wear and 

pressure from time to time.