Mash SIDE FORCE 445cc, User Manual

46

47

Back to summary

Cleaning :

Cleaners that are too acidic or aggressive are not recommended for washing the 

sidecar. In particular at the level of the axes, bearings, levers, pivots, wheels and 

spokes. However, if it is necessary to use it for stubborn stains, follow the instructions 

and application times of the product. We recommend that you spray an anti-corrosion 

product on these elements after rinsing with plenty of water.

Plastic parts and windscreens (for equipped vehicles) should be cleaned preferably 

with water using a sponge or soft cloth. Only a mild detergent can be used if certain 

plastic parts cannot be cleaned properly. Thoroughly rinse the product used: poorly 

rinsed, it could damage the plastic parts. The use of any other products on plastic 

parts is strictly discouraged (thinner, solvent, gasoline, antifreeze, abrasive cleaner, 

etc.).

 Caution

Special precautions: Do not use a high pressure or steam jet cleaner: Avoid 

directing the water jet near the following elements: on-board instruments, brake 

cylinders and calipers, under the fuel tank, transmission chain, bearings steering 

column, seals, air box, wheel or swingarm bearings, all electrical components as 

well as air vents. Water infiltration could damage these elements.

After use under normal conditions:

Clean with lukewarm water mixed with a mild detergent using a soft sponge then 

rinse thoroughly. A damp cloth placed for a few minutes on the parts with more 

stubborn stains and insects will gently remove the dirt.

After use in the rain, near the sea or on salty roads:

Clean the sidecar with cold water and mild detergent: do not use hot water, as this 

will increase the corrosive action of the salt. Protect the vehicle from corrosion by 

spraying an anti-corrosion product on all metal, chrome or nickel-plated surfaces.

After cleaning:

Dry the body parts with a chamois leather or a soft paper towel. After being dried 

with a single-use disposable cloth, the transmission chain must be lubricated with a 

specific lubricant to prevent it from rusting. It is advisable to rub chrome or stainless 

steel parts (including the exhaust system) with a chrome maintenance product. 

An anti-corrosion product should be sprayed on all metal, chrome or nickel-plated 

surfaces. Lubricate pivot pins, bolts and nuts. Apply wax to all painted parts.

 Caution

Special precautions: Never use lubricating or greasy products on the braking 

elements. This could reduce braking efficiency and cause an accident.

Always use a specific degreaser for braking systems