29
Start riding the motorcycle
Firmly press the clutch grip, wait a little moment, press down the gear lever to
engage the first gear, rotate the accelerator grip slowly to you and smoothly and
slowly release the clutch grip. When the clutch is engaged, the motorcycle will
move forward.
To change into a higher speed gear, firstly decelerate a little, release the
accelerator and, at the same time, press the clutch grip, shift the gear lever to
the next higher speed gear position and release the clutch grip, slightly rotate
the accelerator. In this way, the highest gear can be engaged gradually.
Note :
For high speed riding, always avoid releasing the accelerator suddenly. it is
advised to wait a moment when the engine is running at 3000-5000rpm before
fully releasing the accelerator. This can prevent the engine from shutdown due
to abnormal combustion.
Riding on a slope:
To shift from a high gear to a low gear, control the speed in a safe speed range
before gear shifting. Otherwise, abrupt deceleration (sudden rise of engine
speed) may happen, causing gear impacts, sever parts wearing, or overbalance
of the vehicle. it is dangerous.
Slope climbing:
When going up a steep slope, the motorcycle may decelerate due to insufficient
power. Then, immediately shift to a low gear to allow the engine running a
normal power range. Pay attention that, gear shifting shall be made quickly to
keep adequate forward momentum of the motorcycle.
When going down a slope, use the engine for braking, by shifting into a lower
gear.
Be sure to keep in mind that, never ride too fast down a slope! Never allow the
engine to run a very high speed for a long time.
Precaution
Start the engine with the transmission in neutral position, the clutch engaged
and rider riding in normal riding position.
Summary of Contents for Two Fifty 250 cc
Page 1: ...User Manuel ...
Page 4: ......
Page 5: ......
Page 62: ...www mashmotors com Votre revendeur mash motors fr ...
