GLASS REMOVAL AND ASSEMBLY
Carry out these procedures only while the heater is standing upright.
1. Remove the louvre by lifting it upwards and outwards.
2. Remove the dress guard, if fitted, by first removing the bottom panel of the cabinet.
3. Remove two fastening screws securing the top glass trim.
4. Slide forward the top glass trim and lift it clear. Note. This will release the top edges of the three glass
pieces. Ensure that they do not drop out. A masking tape strap around the glass at each front corner is
useful for this.
5. Lift the front glass clear.
6. Lift each side glass clear. They will reveal at their rear edges a glass sealing rope, a backing strip and a
spring.
7. Assembly is the reverse of the above. Clean the inside surfaces of the glass and keep fingerprints off them as
they are assembled. First assemble the side glasses to the heater. Fit the spring first, then the backing strip,
then the rope and finally the glass.
8. Fit both side glasses in place so that their SMOOTH EDGES WILL BE AGAINST THE FRONT
GLASS. The front glass can then be fitted, TAKING CARE THAT THE BEVELLED EDGES FACE
THE FRONT (i.e. away from the side glasses). Offer the front glass into position with its lower edge just
above the top of the bottom retaining channel. Press the front glass back against the side glasses,
compressing the springs until it the glass is directly above the channel. Maintaining the backward pressure,
slide the front glass down into the channel.
9. For safety, fix the two top front corners of the glasses together with sticky tape to prevent them from falling
outwards.
10. Replace the top glass trim, fit its fastening screws, remove the sticky tape and refit the louvre.
REMOVING THE BURNERS
1. Remove the glass (see page 12).
2. Lift the logs out carefully.
3. Inside the firebox, remove the secondary air covers, one at each end of the front burner. (2 screws for each
cover)
12
