EARTH TAB RIVET BN11
Figure 2. Fan switch
11.
Connect the loose earth wire (green) to the brass tab at rear of the left side of
pedestal, this is a push
-
on connection.
12.
Lift the fan assembly and secure to the back of the pedestal with 4 black
screws supplied. For ease of fitment, put the top screws first, then the bottom
ones as shown in Figure 1.
13.
Plug the 3
-
pin plug into the wall outlet and test the operation of the fan.
FAN BOX INSTALLATION OF :
AUS MODEL
-
R5000 LEG & NZ MODEL
-
R5000LEG (Figure 3)
1.
Break out the ‘knock out’ part on the left side of the leg (looking from the front)
to allow the switch to be inserted.
2.
Remove the sharp tabs left in the hole with a file.
3.
Stick the fan operation decal next to this hole. Remove the rear brace from the
back of the heater, as shown in Figure 3 and discard this part.
4.
Fit the EARTH TAB RIVET BN11 ...from inside the back leg channel
-
hole
size 5.2.mm if supplied . (This may have already done in the factory).
Figure 3. Leg version installation
