23
7
10
11
12
8
9
Take the hexagon screw driver *1 with the screw,
stabilize the pulley plate assembly by screwing
the hexagon screw in the front part of the
assembly with the seat side plate notch.
Between the armrest and the back rest, use a screw
driver toscrew M5 screw *1 into posion.
1. Check to see that the armrest can’t be pulled forward
2. Check that it does not aect the laying down posion
when operang
From the back part of the chair’s power supply, pull o
the pre-connected air pipe,while leaving it in the cloth
cover. Insert the armrest air pipe through the cloth cover.
Plug theair pipe,matching the number of the air pipe to
the powerunit, 5, 6, 7 and 8,and opposite 1,2,3,4 set with
the power unit.
Screw the assembly into position
Pull out the side plate leather and stick it
firmly on the side.
Plug on the power cord and return the back
rest to its home position.
Armrest Setup Intructions