Introduction
01A01-24
MF 400 Xtra
01
Method of application for LOCTITE products
a) Remove all traces of old glue, dirt, grease, and
oxidation.
For that, use wire brushes or sandpaper or
chemical remover.
b) Use a dry cloth on the points where adhesives
are applied.
c) Degrease the components with proper solvent
such as LOCTITE 706.
d) Allow time for the solvent to evaporate
completely.
e) Apply the recommended product by using a
clean brush.
In order to apply adhesive as a thread use the
opening of the package.
NOTES:
After applying the product, assemble
as soon as possible.
Do not use product in excess. To
avoid:
-
Locking adjacent components.
-
Difficulty in curing, which usually only
occurs with lack of oxygen.
-
Oil contamination inside mechanical
assemblies and/or obstruction of
hydraulic or lubrication circuits.
The bolts should be tightened and
the parts should be joined as soon
as possible. After curing (drying) the
adhesive, do not tighten again or the
sealing lock or film may be broken.
Grease application
When using grease in components that are in
contact with transmission oil, use special grease,
which can be diluted in oil, thus preventing filters
and circuits from being clogged.
Summary of Contents for 425X
