1 - 12
INTRODUCTION
Tractor identification and technical specifications
2-6 Power take-off specifications
Type:
Independent
Type of clutch:
Mechanical with two speeds 540/750 or 540/1000 RPM
Electrohydraulic with 2 or 4 speeds engaged by a hydraulic clutch
and with electrohydraulic control
PTO output shaft
In compliance with Asae standards13/8 (34.9 mm) with 6 splines
PTO speed
Rotation rate
540 RPM with engine at 2070 RPM
540 ECO RPM with engine at 1339 RPM
(Basic assembly). (2-speed PTO).
540 ECO RPM with engine at 1373 RPM
(on request). (4-speed hydraulic PTO).
1000 RPM with engine at 2107 RPM
(on request). (4-speed hydraulic PTO).
540 RPM PTO with drive reversal with engine at 2061 RPM
(on request 4-speed PTO in certain markets only).
PTO proportional to ground speed (MF 2210); PTO shaft turns per wheel
revolution: 10.677 (10 / 51 rear final drives).
PTO proportional to ground speed (MF 2225-2235); PTO shaft turns per
wheel revolution: 10.769 (11 / 62 rear final drives).
2-7 2WD axle
Type:
Boxed and swivelling around the central pivot
N° tracks
4
Min. track width
1320 mm
Max. track width
1620 mm
Track width increases
100 mm
Max. turning angle
55°
Max. angle of oscillation
12°
Fig. 6-1
