11
3.1 Extended installation options
As illustrated in picture 2, a
LED-lightsignal can additionally
be installed to the 4 soldering
pins. The LEDs need a common
„+ pole“ (anode). A resistor is not
required for the LEDs, since the
powersupply from the Massoth-
ITC-Signaldecoder is automatically
limited to 20mA. If a resistor at the
lightsignal is already existant, it
is harmless. The LEDs might just
glow a little less.
3.1 Erweiterte Anschluss-
möglichkeiten
Zusätzlich kann wie in Bild 2
dargestellt ein LED-Lichtsignal
an die 4 Lötstifte angeschlossen
werden. Die LEDs benötigen einen
gemeinsamen „+ Pol“ (Anode).
Ein Vorwiderstand für die LEDs ist
nicht erforderlich, da der Strom
vom PZB/IR-Signaldecoder auto-
matisch auf 20mA begrenzt wird.
Ein eventuell beim Lichtsignal
bereits vorhandener Vorwiderstand
ist unschädlich. Möglicherweise
leuchten die LEDs etwas dunkler.
gelb / yellow
grün / green
+
rot / red
Rotsperre-LED
Redlight-LED
Gleis
Track
(DCC)
braun / brown
schwarz / black
Abbildung 2: Anschlusskabel anlöten
Illustration 2: Connecting the power input